Suburban Machinery/Software Division Suburban Machinery
Software, Inc.
37777 Harlow Dr., Willoughby, OH 44094 (440) 951-8974 Fax: (440) 951-1412		 Software Division HomeHome Contact Suburban MachineryContact SoftwareSoftware

Technical articles about DNC

 

    We've learned a lot about shop floor communications in the last 14 years, so we thought we'd share some of our experience with you. Check out any of the articles listed below.
Use your Personal Computer for DNC
    An article by Dan Fritz. Published in Modern Machine Shop magazine in September '86 and reprinted in November '91. Includes two BASIC programs for DNC.

DNC puts the probe to work
    An article by Kim Smith, quality control engineer for Falk Corporation. Ms. Smith describes how a custom DNC system from Suburban Machinery helped integrate their robotic cell.

Keeping your shop on-line
    An article by Dan Fritz describing how you can avoid common shop-floor electrical problems such as ground-loops, power surges and, EMI/RFI interference.

Touch-Probe Digitizing

An article by Dan Fritz describing the use of a spindle mounted touch-probe to digitize complex surfaces.